Contact Support

Set up a BK22

How to Setup and Perform Basic Configuration for the BK22

The Verkada BK22 Alarm Keypad is a multifunctional device used to arm or disarm partitions with a keycode, view device statuses, and wirelessly connect intrusion sensors.

You can also use existing alarm wiring to connect keypads to the BP52 alarm panel. This has the advantage of saving you time and money on installation by reusing existing cabling.

Requirements

  • The BK22 must be mounted horizontally (landscape orientation).

  • The table below outlines the connectivity requirements:

Site with cameras only

Site with sensors only

Site with both cameras and sensors

Connection Requirements

PoE (internet and power)

RS485 to BP52

OR

PoE with local LAN on the same network as BP52

RS485 to BP52

OR

PoE with local LAN on the same network as BP52

The keypad must be running the latest firmware to use the LAN-connected BK22 with the BP52. When connected to the network, keypads update automatically. Allow the update to complete fully before testing functionality.

Installation (RS485)

1

Attach a 4 conductor wire to the BK22 (located in the back) to +,-,1A,1B.

Note: Be mindful of the colors, as they must match the other side of the panel.

Could not display content

2

Connect the other end of the cable to the BP52.

Could not display content

3

Add the BK22 serial number or order number to Command.

Verify the BK22 is powered on and online in Command. When the panel detects the keypad, click Confirm to establish the connection.

Could not display content

Installation (PoE) ​

1

Attach a PoE cable to the back of the BK-22. To enable the BK22 to also see sensor partitions, the BP52 and BK22 must be on the same local network. If video monitoring is only used, the device will just need access to the internet as a BP52 is not required for Camera only partitions.

2

Add the BK22 serial number or order number to Command.

3

Verify the BK22 is powered on and online in Command. For LAN based keypads, you should see 2 events

a. "Online" indicating the keypad has internet access and b. "Connected to panel" indicating the keypad has connection to the BP52.

Configuration

1

The image below shows the default landing screen for the BK22. Use this screen to view/change the Arm/Disarm status once you add an alarm Keycode.

2

Enter your keycode to test the arm/disarm functionality. Here, you can see all configured partitions for the alarm system.

a. If there is only one partition, then you will see the below image.

b. To configure more details, click in the top right. Here, you will be able to configure the following:

  • Console LED

  • Volume

  • Brightness

  • Lock Screen in - time it takes after entering the keycode and no activity for the device to relock.

  • Home Screen - selectable home screen types, choices between an analog clock, nebula background, and the default digital clock.

  • Alarm Sound - sound the alarm console makes when there is an active alarm.

  • Mode - dark or light color scheme.

  • Door Chime - select the door contact under devices on the keypad > Device > Play Chime

k. Swipe right on the home screen to view a list of all the devices in the site. Click on a device to view its past events and more information.

After a keycode is entered into the BK22, the device can be armed or disarmed without re-entering the keycode for 1 minute and 30 seconds. You can override this timer and immediately lock the device by pressing the back button in the top left corner.

Follow the install guide to mount your keypad after testing the functionality.

Prefer to see it in action? Check out the video tutorial.

Need more help? Contact Verkada Support.

Last updated

Was this helpful?