Mount a TD52

Learn how to mount the Verkada TD52 Video Intercom

Use this article to learn how to mount a Verkada Intercom (TD52). Once you complete the mounting, you can connect the TD52 to the network.

Before you begin

You can mount the TD52 using a flush mount or using a mounting bracket. We recommend that you verify the contents of your box and make sure you have the tools you need

Contents of your box

• TD52 video intercom

• Flush mount plate

• T10 security Torx screwdriver

• 2 grommets

• Grommet punch

• 4 drywall screws

• 4 drywall anchors

• 4 M4x18mm machine screws

• 4 8–32¾" machine screws

Tools you need

• A working internet connection

• A smartphone or laptop

• A #2 Phillips head and power drill

• A level

Choose your mounting option

Whichever mounting option you choose, you should remove the front cover of the TD52 to access the screw holes that allow you to install on a mount.

1

At the bottom of the front cover, with a T10 security Torx screwdriver, remove the security screws.

2

Slide the front cover up and then out.

3

When the front cover is removed there are four screw holes in each corner of the TD52. You use these screw holes to install the TD52 to the mount.

Use a flush mount

The TD52 comes with a flush mount in the box. You can use the screw holes of the flush mount to mount the Intercom (see image below for visual):

• Legacy intercom back box (A)

• Direct wall mounting (B)

• 4 gang junction box mounting (C)

• You can use screw holes corresponding to A to mount to an existing intercom back box

• You can use screw holes corresponding to C to mount to a 4 gang junction box

Mount directly to a wall

1

Place and hold the flush mount plate and against the desired surface.

2

Using the mount plate as a template, mark the wall to line up with screw holes labeled "B".

3

Drill pilot holes in to the wall:

a. For direct mounting, drill a .11 in (3mm) pilot hole. b. If using wall anchors, drill a .23 inch (6mm) pilot hole.

4

Use the screws supplied to attach the mount plate to the wall.

5

With the flush mount plate on the wall, use the included Torx screwdriver to remove the screws on the bottom of the faceplate (front cover of the TD52).

6

Place the TD52 on top of the flush mount plate and install it using the supplied screws.

Use a mounting bracket

You can use the mounting bracket to install the TD52 on to various surfaces that the flush mount plate cannot, where they’re typically used to mount the TD52 on an exterior surface.

1

Place and hold the mounting bracket against the desired surface.

2

Using the mount as a template, mark surface through screw holes labeled "A".

3

Drill pilot holes into the wall:

a. For direct mounting, drill a .11 in (3mm) pilot hole. b. if wall anchors are being used drill a .23 inch (6mm) pilot hole.

4

Use the screws supplied to install the mounting bracket on the wall.

5

With the mounting bracket installed, remove the front cover from the TD52.

6

Place the TD52 on top of the mounting bracket and install it using the supplied screws.

---

Need more help? Contact Verkada Support.