The WH32 is a wireless repeater that can extend the wireless range of a wired hub to improve coverage in areas where running cable is difficult. It can also operate as a hub when connected directly to the alarm panel via RS-485.
Requirements
WH32 as a wireless repeater (DC powered) - Requires 10-36V DC power supply (such as the ACC-WA-30W-NA). The WH32 will extend the wireless range from any device with a hub, such as the BP52, WH52, WH32 (RS485), BK22, or BE32.
WH32 as a hub (RS485) - Must be directly connected to the BP52 via one of its RS485 ports.
Installation best practices
Install the WH32 facing down on the ceiling for the best wireless performance. Vertical wall mountings are also acceptable if ceiling mounting is not possible.
See Wireless Installation FAQ for more information on optimal repeater placement.
WH32 setup
Ensure that a BP52 is added to your New Alarms site and online.
Add the WH32 serial number to your Command account.
Move the WH32 from unassigned devices to your New Alarms site.
Repeater mode
In repeater mode, power the device (10–36V DC) and turn it on using the power switch. The WH32 will automatically connect to the nearest hub.
Check the device activity to confirm it is connected and that the RSSI signal strength is -80 dBm or better.
Hub mode
Connect the WH32 to the alarm panel via RS-485.
Verify the WH32 displays a “connected” event, confirming communication with the panel and readiness to route alarm events.
FAQ
In repeater mode, how far should the WH32 be placed from the hub it is extending?
In repeater mode, how far should the WH32 be placed from the hub it is extending?
Optimal placement depends on environmental factors such as wall material, thickness, and obstructions. To maximize range, position the WH32 as far from the hub as possible while maintaining a signal strength of at least -80 dBm RSSI. If the RSSI falls below this threshold, move the WH32 closer to the hub.
Installation Tip: Avoid placing the WH32 near metal walls or enclosures, as this can significantly reduce wireless performance.
How often does the WH32 update its signal strength reading?
How often does the WH32 update its signal strength reading?
The RSSI reading updates every minute in Command.
Can multiple WH32 devices repeat signals in sequence?
Can multiple WH32 devices repeat signals in sequence?
No. The WH32 can only repeat from a wired hub, not from another WH32 in repeater mode.
How does the WH32 switch between wired hub and repeater mode?
How does the WH32 switch between wired hub and repeater mode?
The WH32 automatically determines its mode:
If it detects an RS-485 connection, it operates in hub mode.
If no RS-485 connection is present, it switches to repeater mode.
How do I power the WH32 in repeater mode?
How do I power the WH32 in repeater mode?
You can use the ACC-WA-30W-NA power adapter (sold separately).
Need more help? Contact Verkada Support.