Use this article to learn how to mount a Verkada Intercom (TD52). Once you complete the mounting, you can connect the TD52 to the network.
What's included in your box
TD52 video intercom
Flush mount plate
T10 security Torx screwdriver
2 grommets
Grommet punch
4 drywall screws
4 drywall anchors
4 M4x18mm machine screws
4 8–32¾” machine screws
What you need
A working internet connection
A smartphone or laptop
A #2 Phillips head and power drill
A level
How to mount the TD52
You can mount the TD52 using a flush mount or using a mounting bracket.
Before you begin
Whichever mounting option you choose, you should remove the front cover of the TD52 to access the screw holes that allow you to install on a mount.
Remove the front cover of the TD52
At the bottom of the front cover, with a T10 security Torx screwdriver, remove the security screws.
Slide the front cover up and then out.
When the front cover is removed there are four screw holes in each corner of the TD52. You use these screw holes to install the TD52 to the mount.
Mount the TD52 using a flush mount
The TD52 comes with a flush mount in the box. You can use the screw holes of the flush mount to mount the Intercom (see image below for visual):
Legacy intercom back box (A)
Direct wall mounting (B)
4 gang junction box mounting (C)
You can use screw holes corresponding to A to mount to an existing intercom back box
You can use screw holes corresponding to C to mount to a 4 gang junction box
Mount directly to a wall
Place and hold the flush mount plate and against the desired surface.
Using the mount plate as a template, mark the wall to line up with screw holes labeled "B".
Drill pilot holes in to the wall:
For direct mounting, drill 3mm (.11 inch) pilot holes.
If using wall anchors, drill 6mm (.23 inch) pilot holes.
Use the screws supplied to attach the mount plate to the wall
With the flush mount plate on the wall, remove the front cover of the TD52.
Place the TD52 on top of the flush mount plate and install it using the supplied screws.
Mount the TD52 using a mounting bracket
You can use the mounting bracket o install the TD52 on to various surfaces that the flush mount plate cannot, where they're typically used to mount the TD52 on an exterior surface.
Place and hold the mounting bracket against the desired surface.
Using the mount as a template, mark surface through screw holes labeled "A".
Drill pilot holes into the wall:
For direct mounting, drill a 3mm (.11 inch) pilot hole.
if wall anchors are being used drill a 6mm (.23 inch) pilot hole.
Use the screws supplied to install the mounting bracket on the wall.
With the mounting bracket installed remove the front cover from the TD52
Place the TD52 on top of the mounting bracket and install it using the supplied screws.